ASSEMBLING THE PRO-V1

 

 

The PRO-V1 is shipped in a flat box to minimise the carbon footprint.

 

It can easily be assembled in less than 5 minutes by following these simple steps.

 

The same instructions are applied when simply changing the visor too.

BUY NOW

ASSEMBLY INSTRUCTIONS

Thank you for purchasing the Carclo Safetywear PRO V1 Professional Series Full Coverage Safety Visor from Carclo Safetywear.

By following the easy steps depicted below, your PRO V1 will quickly be ready to use allowing you to confidently carry out your activities with the knowledge you’ve taken steps to remain safe in the new environments.

DOWNLOAD THE ASSEMBLY INSTRUCTIONS PDF

CLEANING YOUR PRO V1

To clean you PRO V1, simply use some warm soapy water and a soft cloth.

Please be aware that excessive scrubbing can damage the anti – fog coating rendering it ineffective.

IMPORTANT: The WHITE film on the visor is attached to the anti – fog side.

The visor MUST be attached with this side facing inwards to be effective.

STEP ONE • THE HEADBAND

Remove the nuts and set aside for later.

Attach the elasticated strap to one side of the headband as shown below.

Bend the headband and attach the strap to the other side.

STEP TWO • THE CENTRE STRAP

Press the pre-assembled centre strap into the headband until it clicks into place.

Turn the unit around, bend the strap over and repeat on the other side.

The headwear unit is now complete.

STEP THREE • THE VISOR

IMPORTANT: The WHITE film on the visor is attached to the anti – fog side.

The visor MUST be attached with this side facing inwards to be effective.

Take the visor and peel back the protective WHITE film about 3cm on both ends to reveal the holes.

Turn the visor over and repeat, this time peeling back the protective CLEAR film.  

Ensuring the straight edge of the visor is at the top and the WHITE film is on the inside, align one of the visor’s holes with a peg and screw one of the nuts in place.

Bend the visor round, align the hole with the peg and secure the visor in place using the remaining screw as depicted beneath.

REMOVING THE FILM 

Now the assembly is complete, simply peel off both the WHITE and CLEAR protective films.

YOUR PRO V1 IS NOW COMPLETE AND READY FOR USE.

We’d like to take this opportunity to thank you for choosing Carclo Safetywear.